How To Flash karbonn A1 Plus Super MTK Smartphone With SP Flash Tools

label

How To Flash karbonn A1 Plus Super MTK Smartphone With SP Flash Tools




Unofficial support site for this Phone By Welcome Zone Haldwani

The Instructions Given Below To Flash Stock Rom Or Any Custom Rom Flash File Firmware using Smart Phone Flash Tool (SP Flash Tool) on Your Android MTK SmartPhone .

Requirements:
1=> Your Android Smartphone should have at-least 40-50 percent of battery to perform the Flashing Process.
2=> SP Flash Tool And Usb Drivers .
        You Can Download It From Last In The Post
3=> USB Cable.

Step 1Download and install Android USB Drivers on your computer From The Link Given Up. In case You Already Installed Android USB Drivers on your Computer then skip this step.


Step 2:  Then Next Step Is Power Off your Android Smartphone and remove the Battery (if it is removable).

Step 3Download And Extract the Stock Rom or Custom Rom that you want to Flash on your Smartphone .

Step 4Download and Extract Smart Phone Flash Tool on Your Computer. After Extracting you will be able to see the following files.

Step 5Now Open Flash_tool.exe .


Step 6When Smart Phone Flash Tool is launched , Click on the Scatter-Loading Button That Is On Right Side .



Step 7Now , Locate the Scatter File (Give The Path Of That File You Extracted In Your Computer).

Step 8Then Next Is Click on the Download Button to begin the Flashing Process.

After Clicking On The Download Button You Can See This Type Of Screen .

Step 9: Now, Connect your Android Smartphone to the Computer Via USB Cable (without battery- if it is removable).


Now One Red Line Is Run ThenThen One Voilet Line Then One Yellow Line Is Run And Then It finished .


Step 10: When Flashing is completed, a Green Download Ok Logo will appear.


Step 11Now You Can Close the Smart Phone Flash Tool In your computer and disconnect your Android Smartphone from the computer .

Note =>  If You want To Flash Only User Data Or Recovery File So Tick Mark Only User Data Or Recovery File .
Deselect all parts except those one you want to flash and then press F9 Or Hit Download Button .



When You Click On The Download Button , The tool will immediately show a warning Message because not all parts are selected, but you should continue anyway, Safely press Yes.


Now Process To Flash Only One File Is Started And Compleated In Just A Minute .





Congratulations, Now your Smartphone is successfully Flashed With the Stock Rom you have Downloaded Or Only User Data Or Recovery File .


karbonn A1 Plus Super Flash FileDownload
karbonn A1 Plus Super Flash ToolDownload
karbonn A1 Plus Super Usb DriverDownload
FacebookPageLike This
Share This :



sentiment_satisfied Emoticon